Simrad Halo - Network Connection

28 |
Wiring |Halo pulse compression radar installation manual
Network
An Ethernet network is used to distribute the radar data to compatible multi-function displays.
The RI-12 is connected to the Ethernet network using a standard Simrad Ethernet cable and the
supplied adapter cable. The RI-12 can be connected either directly to any Simrad compatible
MFD or to a network switch such as an NEP-2 or SonarHub.
1
2
3
4
4
5
6
6
NETWORK /MFD
No. Description
1
Halo® pulse compression radar pedestal and antenna
2
Multi-function displays
3
RI-12 interface module
4
RJ45 to 5 pin yellow Ethernet adapter (p/n 000-11246-001)
5
NEP-2 or device with a built in Ethernet switch
6 Ethernet cables. Supplied with a 1.8 m (6 ft). The RI-12 can connect either directly
to a multifunction display or to other an Ethernet switch such as NEP2 or SonarHub