How to fix Simrad CA34 when there is no picture on the display screen?
If there's no picture on your Simrad Radar display screen, first, try pressing the [PWR] key on the keypad. If that doesn't work, the fuse might be blown. Replace it with a T6.3A slow type (5x20 mm).
What to do if Simrad CA34 has no normal picture or key operation?
If your Simrad Radar isn't displaying a normal picture or the keys aren't working, try these steps: * Turn the unit off and then on again. * Disconnect the power, and then reconnect it. * If you have a C-MAP chart inserted, remove it in case it's defective. * Restore the unit to factory presets.
How to adjust Simrad CA34 Radar with too much noise in the display?
If there is too much noise in your Simrad Radar display, adjust the TUNE.
What to do if Simrad CA34 Radar echo picture is normal, but no targets are shown?
If the echo picture on your Simrad Radar appears normal but no targets are shown, or you only see random noise, try the following: 1. Change the frequency from the Echo quick menu. 2. Ensure the connectors are correctly connected to the unit. 3. Increase the receiver gain. 4. Adjust the range.
How to adjust brightness on Simrad CA34 Radar display?
If the image on your Simrad Radar display is too dark or too bright, press [PWR], adjust the light, and then press [ENT].
Why is there excessive noise in the Simrad CA34 echo picture?
If you're experiencing excessive noise in the echo picture of your Simrad Radar, ensure that all connected equipment is properly grounded to the main unit.
Why does the Simrad CA34 echo image differ from the actual image?
If the echo image on your Simrad Radar display differs from the actual image, ensure that the ship’s heading and the Zero Range are set correctly.
What to do if Simrad Radar has no GPS position update?
If your Simrad Radar is not getting GPS position updates, try replacing the antenna or the cable.
Why is the Simrad CA34 screen update extremely slow?
If the screen update on your Simrad Radar is extremely slow, turn off ‘Course line’ for each stored route and turn off ‘Display track’.
Why is all data deleted on my Simrad CA34 Radar after turning it off?
If all data on your Simrad Radar is deleted after turning it off and on, the internal battery likely needs replacement by an authorized dealer. The expected battery lifetime is a minimum of 5 years.
To Next Page
General
