Need help?Do you have a question about the Simrad HALO 2000 Series and is the answer not in the manual?
Details regulatory compliance with UKCA standards for radio equipment.
Confirms compliance with CE marking for EU directives related to radar systems.
Crucial safety precautions for operating and installing the radar system.
Details the parts included for the radar pedestal assembly.
Lists the parts for the radar antenna, including different sizes.
Identifies the components of the RI-50 radar interface module.
Highlights what 'not to do' during radar installation to ensure safety.
Specifies safe distances from compasses to avoid interference.
Guidance for installing multiple radars and on power boats.
Advice on mounting the radar on a vessel's roof or hard top.
Steps for installing the RI-50 radar interface module.
Instructions on how to run and secure the radar interconnection cable.
Procedure for mounting the radar pedestal to the vessel.
Steps for fitting the radar antenna to the mounted pedestal.
Diagram and explanation of the RI-50 circuit board connections.
Guidance on running and preparing cables for connection.
How to connect the radar pedestal to the RI-50 module.
Instructions for connecting the radar's power supply.
Procedure for properly grounding the RI-50 unit.
Enabling the radar to be controlled by a multi-function display or ignition.
Setting up the radar antenna to park in a specific position.
Connecting the radar to the vessel's Ethernet network.
Information on functions like VelocityTrack and ZoneTrack.
Steps to start the radar system after installation.
Explanation of the LED lights on the RI-50 for status monitoring.
Information regarding the RI-50's fuse and its indications.
Setting up radar source, status, and system reset procedures.
Configuring antenna position, alignment, suppression, and blanking.
Controlling the brightness of the pedestal's blue accent light.
Troubleshooting guidance for radar error codes.
Note-taking of existing radar settings before an upgrade.
Steps to safely disconnect power and remove old radar parts.
Guidance for installing the new RI-50 and pedestal.
Technical drawings and measurements for the RI-50 module.
Detailed measurements for the pedestal and various antenna sizes.
Diagram showing the turning diameter of different antenna models.
To Next Page
General
