PAGE | 43
Install the RI-50 and new pedestal
To install the RI-50 and your new HALO 2000 SERIES or HALO 3000 SERIES pedestal, follow the
steps in the Hardware mounting and Wiring sections in this manual.
¼ Note: If you are re-using the original interconnection cable, only connect four wires to the 4-way
SCANNER POWER connector on the circuit board. You won’t use the 2-way connector.
POWER
CONTROLLED BY
AUX REMOTE
24V ONLY
12/24V
Always ON
RI-50
SHIELD
CASE / SHIP
GND
12/24V 20A
To Next Page
Loading...
