PAGE | 23
5
6 Apply the supplied Tef-Gel
®
anti-corrosion gel to the four feet of the pedestal.
7 Lower the pedestal so its mounting holes align with the drilled holes in the mounting plate.
8
9 Apply the Tef-Gel
®
anti-corrosion gel to the threads of each bolt.
10 Insert the bolts through the drilled holes and into the pedestal’s threaded mounting holes.
Tighten the bolts securely.
¼ Note: The torque settings for the mounting bolts are 30 N.m – 40 N.m (22.1 lb-ft – 39.5 lb-ft).
Fit the antenna to the pedestal
⚠ Warning: Do not operate the radar without the antenna connected.
1 Remove the waveguide protection cap from the pedestal and the waveguide protection label
from the underside of the antenna.
¼ Note: The cap and label prevent contaminants from entering the waveguide. You should only
remove these covers just before you t the antenna to the pedestal.
To Next Page
Loading...
