PAGE | 42
8 If re-using the antenna, cover the waveguide to protect it from water and contaminants.
Remove the RI-12
9 Remove the circuit board cover from the RI-12 by unscrewing the six retaining screws.
10 Remove the grommet retaining clip.
11 Remove the rubber grommets.
12 Disconnect the power cable from the SUPPLY connector.
13 Unplug the RJ45 connector end of the interconnection cable from the SCANNER connector.
¼ Note: Keep wires connected to RJ45 connector.
14 Unplug the green 4-way connector from SCANNER POWER connector.
¼ Note: Keep wires connected to 4-way connector.
15 If used, unplug the AUX connector.
¼ Note: Keep wires connected to the AUX connector.
16 Unplug the Ethernet cable.
17 Unplug the Micro-C NMEA 2000
®
connector (This cable can be removed as it is not needed with
the RI-50 interface module.)
18 Unscrew the RI-12 from its mounted location.
19 Remove the grounding wire if used.
To Next Page
Loading...
