PAGE | 28
6 Pass the cables through the rubber grommets and into the RI-50. For cables with connectors,
you need to cut a slit between the hole and edge of the grommet.
Connect the interconnection cable
To receive Ethernet data from the radar, connect the RJ45 connector end of the interconnection
cable to the SCANNER connector on the circuit board.
the 4-way and 2-way SCANNER POWER connectors on the circuit board, matching the color-coded
POWER
CONTROLLED BY
AUX REMOTE
24V ONLY
12/24V
Always ON
RI-50
SHIELD
CASE / SHIP
GND
12/24V 20A
To Next Page
Loading...
