PAGE | 40
Error codes
If you encounter an error code, power cycle the radar. If the error code reappears, refer to this list
for guidance.
Error code Description Recommendation
0x00000001 Radar saved settings
corrupted
Radar will revert to factory defaults. Re-enter your
settings including installation settings.
0x0001000C Scanner not detected
voltage.
0x0001000D Transmitter overheat (soft) Try changing to shorter ranges <6 NM. Switch to
STBY. Allow unit cool.
0x0001000E Transmitter overheat (hard) Switch to STBY. Isolate power to the radar and
contact service.
0x0001000F Signal processing error Unit should revert to STBY. Select transmit.
If problem persists, power cycle the radar.
0x00010017 Scanner failure Contact service
Power supply
0x00010010 Power supply overheating Switch to STBY. Allow unit to cool then retry.
0x00010011 Power supply voltage error
or damage.
0x00010012 Power supply overload Contact service
0x00010013 Power supply hardware
fault
Contact service
0x00010014 Power supply comms fault Contact service
0x00010019 Low battery voltage (Supply
voltage low)
radar.
0x00010016 LED Lighting fault
0x00010018 Radar interface box fault
interconnection cable for damage.
Mechanical
0x00010001 Zero bearing sensor fault Contact service
0x00010002 Bearing sensor fault Contact service
0x00010015 Mechanical transmission
fault
Contact service
0x00010003 Motor drive fault Contact service
0x0001001A Motor or antenna has
stalled
obstructions such as ice.
To Next Page
Loading...
