PAGE | 18
Run the interconnection cable
The 14-pin connector end of the cable connects to the pedestal. The RJ45 connector connects to
the RI-50 radar interface module.
1
hole to pass the 14-pin connector from the RI-50 to the pedestal.
2 To protect the connectors, especially the RJ45 connector, when pulling the cable through the
3
4 Tape the wires and the RJ45 connector to the mouse line so they do not get caught and bend
A
B B
A
Mouse line
B
Electrical tape
C
Cable tie
5 Carefully pull the interconnection cable through the vessel so it runs between the RI-50 radar
interface module and your chosen pedestal location.
Install the pedestal
⚠ Warning: Leave the waveguide protection cap on the pedestal while you mount it
to your vessel. You should only remove the cap just before you t the antenna to the
pedestal.
Bolts and washers
•
•
If using longer bolts, ensure they are marine-grade stainless steel and allow for a minimum of
⚠ Important: Apply a light coating of the supplied Tef-Gel
®
or other suitable nickel- or
PTFE-based lubricant to the mounting bolts to prevent galling and corrosion.
To Next Page
Loading...
