PAGE | 31
Alternatively, you can ground the RI-50 using the CASE / SHIP GND spade terminal on the circuit
board.
POWER
CONTROLLED BY
AUX REMOTE
24V ONLY
12/24V
Always ON
RI-50
SHIELD
CASE / SHIP
GND
12/24V 20A
Activate remote power control
The RI-50 has an optional remote power control mode that enables a compatible multi-function
display or ignition switch to control the power state of the radar. When the display or switch is
turned on, the radar will turn on.
To use the remote power control function:
1 Move the power control switch from Always ON (indicated by ON on the switch itself) to POWER
CONTROLLED BY AUX REMOTE (indicated by 1 on the switch).
2 Apply +V DC (5 V DC - 32 V DC) from a compatible multi-function display or ignition switch to the
Remote input of the AUX connector. On a compatible multi-function display, this is the yellow
wire in the power cable.
3 If you are using a multi-function display to power on the radar, set it to master (refer to the
power control function in the display’s user manual for instructions).
¼ Notes:
• Always ON, the power wire in the AUX Remote
port is ignored.
•
the antenna before shutting down.
• There must be a common battery -ve for all devices on the power control bus.
POWER
CONTROLLED BY
AUX REMOTE
24V ONLY
12/24V
Always ON
RI-50
SHIELD
CASE / SHIP
GND
12/24V 20A
To Next Page
Loading...
