PAGE | 41
UPGRADING
powerful motor and higher transmit power.
change the interconnection cable.
the existing interconnection cable but we recommend you inspect the condition of the connectors.
¼ Note: At the time of release, HALO 2000 SERIES and HALO 3000 SERIES radars work with Simrad
®
GO XSR, GO XSE (9/12), NSS evo3, NSS evo3S, NSO evo3, NSO evo3S and NSO evo3S MPU systems.
They also work with Simrad
®
R2009 and R3016 radar control units.
Record the old settings
1
will help you set up your new radar on the display unit.
Isolate power to the radar
2
Remove the old pedestal
3 0 (power supply disabled).
4 Disconnect the interconnection cable from the pedestal.
5 Cover the 14-pin end of the interconnection cable to protect it from water and contaminants.
6
pedestal.
7
To Next Page
Loading...
Need help?
General
