CA34/44/54 Radar menu Chapter 3-17
3.2.6 Radar quick menu
From active radar display:
ENT
Call up the Radar quick menu
Radar quick menu
RADAR
Power On
GOTO
Transmit
1
Activate EBL-VRM1
2
Activate EBL-VRM2
3
Activate Cursor
4
Show Navigation Point
5
Heading Line
6
Clear Trails
CHART
Show Overlay Chart
PLOT
Show Overlay User Data
ADJ
Overlay Chart Setup
MENU
Exit
If working with both EBL-VRM cursors, you can toggle between
which one should be active via the quick menu.
RADAR
Power On/Off - Turning power on will activate scanner warm up
and enter standby mode, see section 3.2.3.
GOTO
Transmit/Standby - Transmit will start transmission and antenna
rotation, see section 3.2.3.
1
Activate EBL-VRM1
A dotted line + circle will be drawn on the screen. Use the cursor key
to move the EBL-VRM1 cursor. By placing the square cursor point
over a target or over an object, it will indicate the distance to same.
To turn off: Press [ENT], [1] again to hide EBL-VRM1.
Long press on [CLR] will turn off all active cursors.
Toggle on/off directly from the [EBL] key.
To Next Page
Loading...
Need help?
General
