Simrad AP50 Autopilot
6 20221032 / E
The JP21 Jack Point can be used for simple connection/
disconnection of the AP51 at different locations on the vessel.
Refer to the AP51 manual.
R3000X Remote Control
This small hand-held remote control has two buttons for power
steering and course selection (port and starboard) and one button
with a built-in lighted indicator for (limited) mode selection.
JS10 Joystick
The JS10 Joystick is a Non-Follow-Up steering lever designed for
indoor and outdoor console mount. It has a spring-loaded return-
to-mid-position feature and is equipped with 10 m (33’) of cable
and installation hardware.
QS50 QuickStick
The QS50 Quick Stick is a 2 axis joystick for arm rest and
desktop mounting and is interfaced to the autopilot via Robnet.
Mode change is made directly with the joystick and by means of
push buttons thruster and WORK mode can be toggled On/Off.
NFU power steering is provided with an automatic center rudder
function.
Refer to the QS50 manual.
S35 NFU Steering Lever
The S35 is designed for indoor and outdoor bulkhead-mounting
and is made of shock resistant polyxymethylene. The lever has a
spring loaded return-to-mid-position feature. Its push button
with light indicator is used for (limited) mode selection when
connected to an autopilot junction unit.
S9 NFU Steering Lever
The S9 is a splash proof steering lever for bulkhead or console
mounting. The housing is made of machined aluminum. The
internal mechanism of the S9 permits locking of the lever in the
mid-position to avoid inadvertent operation. When the S9 handle
is pulled out, the autopilot will be disengaged. When connected
to the AP50, the S9 can also be wired for direct NFU override
steering.
To Next Page
Loading...
Need help?
General
