Simrad Mercury - Mercury Controller Introduction and Setup; Overview of Mercury Controller; Safety Guidelines for Controller Use; System Requirements for Mercury Controller

4
OVERVIEW
The Mercury controller is a navigation tool that automatically keeps vessels equipped with a Mercury
Marine engine at a steady speed via cruise or troll control modes.
SAFETY
⚠ WARNING: An engine controller is a useful navigational aid, but it does not replace
a human navigator. Ensure the system has been installed correctly, commissioned and
calibrated before use.
Do not use cruise/troll control when in:
• Heavy marine trac areas or narrow waters.
• Poor visibility or extreme sea conditions.
• Areas where use of a cruise control system is prohibited by law.
When using the cruise/troll control:
• Do not leave the helm unattended.
• Do not place any magnetic material or equipment near the heading sensor used by the autopilot
system.
• At regular intervals, verify the course and position of the vessel.
• Reduce speed in time to avoid hazardous situations.
REQUIREMENTS
To view the Mercury controller, you need the following:
• NSX MFD with software version 1.3.257 or later.
• A fully installed and commissioned Mercury engine. Up to four engines are supported.
• A correctly congured Mercury SmartCraft Connect module.
Refer to the Mercury Marine SmartCraft Connect website for further information.
¼ NOTE: Contact Mercury for all information on hardware and installation procedures. We recommend
professional installation of your Mercury engine, SmartCraft Connect gateway, and helm assignment.