6
CRUISE CONTROL
Cruise control is a speed limiting function which can be activated above trolling speed. The minimum and
maximum engine RPM should be congured by your engine and/or SmartCraft Connect installer.
¼ NOTE: Cruise control can only be engaged in F (Forward) or R (Reverse) throttle positions.
Engage cruise control
Follow these steps to engage cruise control when it is safe to do so.
A
E
B
C
D
D
B
F
4000
1 Engage F (Forward) or R (Reverse) to the desired the RPM.
2 Select the cruise control RPM button (A).
3 Use the +/- buttons (B) to set the cruise control target RPM (E). Select and hold to change the RPM
rapidly.
4 Select START (C) to engage cruise control.
5 Move your throttle to match the cruise control target RPM. You can check the current engine RPM via
the gray sweep indicator or engine RPM display (F).
6 Active is displayed when the engine has reached the target RPM.
7 Once active, you can adjust the cruise control RPM via the +/- buttons (B).
¼ Note: If you move the throttle position beyond the cruise control target RPM, you may experience a
momentary surge, but the cruise control system will rapidly match the engine RPM to the target RPM.
⚠ WARNING: When you need to slow down in an emergency, lower the throttle position to
override the cruise control. If you need to exceed the cruise control target RPM, select STOP
(D) to disengage cruise control before increasing your throttle input.
Disengage cruise control
Your engine will maintain the target RPM until cruise control is disengaged or the throttle position is
reduced below the cruise control target RPM.
To disengage cruise control select STOP (D) then move the throttle to neutral or idle position.
To Next Page
Loading...
Need help?
General
