Simrad Mercury - Troll Control Functionality

7
TROLL CONTROL
Use troll control as a low-speed engine RPM limiter when shing, surveying, navigating a busy harbor/
speed restricted area/no-wake zone, or when your maximum vessel speed must be lower than the
minimum cruise RPM.
The minimum and maximum troll control RPM should be congured by your engine and/or SmartCraft
Connect installer. The values for minimum and maximum limits are provided by the gateway, for both
cruise and troll. Correct conguration of the gateway is required for these values to be correct on the
MFD.
¼ NOTE: Troll control can only be engaged with the throttle in the forward idle position, and engine RPMs
are controlled via the Mercury engine controller.
Engage troll control
Follow these steps to engage troll control when it is safe to do so.
A
B
D
C
E
F
D
B
1 Set the throttle to the forward idle position.
2 Select the troll control RPM panel (A).
3 Use the +/- buttons (B) to set the troll control target RPM. Select and hold to change the RPM rapidly.
4 Select START (C), and the engine RPM (F) will immediately match the target RPM.
5 Once active, you can adjust the troll control RPM via the +/- buttons (B).
6 Select STOP (D) to disengage troll control.
¼ Note: Troll control is disengaged when the throttle position is changed.
Disengage troll control
Troll control can be disengaged by selecting STOP or changing the throttle position.