32 |
System conguration | MX610/MX612 Operator and Installation manual
List of NMEA messages supported by the Junction Box
Classification NMEA Message Description
GPS
GGA GPS system fix data
GLL Geographic position
GSA GNSS DOP and Active Satellites
GSV GNSS Satellites in view
GRS GNSS Range Residuals
GBS GNSS Satellite Fault Detection
GNS GNSS Fix Data
VTG Course over ground and speed over ground
ZDA Time and Date
DTM Datum
RMC Recommended minimum specific GNSS data
RMB Recommended minimum navigation information
ALR* Set alarm state*
NAV
APB Autopilot Sentence “B”
XTE Cross-Track error
WPL Waypoint Location
RTE Routes
ECHO
DPT Depth
VHW Water speed and heading
Compass
HDG Heading, deviation and variation
HDT Heading, True
ROT Rate of Turn
THS True heading and status
AIS* VDx* AIS messages (VDO & VDM)*
* Consideration for future implementation
Printer Output
This menu item controls the printer output. NMEA ports 1 or 2
can be configured to output to a printer. Printer time settings
are Off, 1 min, 30 min, 1 hr, 2 hr or 3 hr interval (typical setting
is 1 hr). Use 1 min to test the printer function, then set it to the
desired print time thereafter.
The printer output is simple ASCII text designed to operate on
any serial printers (i.e. EPSON thermal printer Model M267A
@ 38,400 baud). An RS-422 to RS-232 converter is needed to
match the electrical standard of the printer.
A sample of the printer format is shown below:
Simrad MX 610/612 Navigation System
========================================
18:06:59 UTC 09 2 2015
Differential GPS Fix
Latitude: 33 48.5084’ N
Longitude: 118 21.0106’ W
COG: 320.76 SOG: 5.00 kn
To Next Page
Loading...
