Radar source
In a system with more than one radar, the correct device to configure can be selected from
this menu.
Ú
Note: Radars that support dual radar mode are represented twice in the source list, with
an A and B suffix.
Radar status
Scanner type
Identifies the model of scanner connected to the network.
Software version
Check to make sure you have the latest software. Check the latest software version available
at: www.simrad-yachting.com.
Serial number
This number should be recorded for support and insurance purposes.
MARPA status
The MARPA status can identify if a heading sensor is on the network and that the radar is
receiving heading information essential for MARPA calculations.
Reset device ID
Should a radar be connected to the network that has been connected to a dual radar
network in the past, it might not be detected by the system because it might have an invalid
Device ID. With the radar connected and powered up, select the Reset Device ID button to
resolve this problem.
Ú
Note: This procedure must be performed with only one radar on the network, and only
applies where a network combines an older MFD with other MFDs.
Adjust range offset
(Pulse Radar only)
22
Software setup | NSO-evo3 Installation Manual
To Next Page
Loading...
