Ú
Note: Changing the mode requires that all connected sources are restarted.
Overlay DownScan
When a DownScan capable transducer is connected to your system, you can overlay
DownScan images on the regular Echosounder image.
When overlay DownScan is activated, the Echosounder panel menu expands to include basic
DownScan options.
Structure depth offset
Setting for Structure transducers.
All transducers measure water depth from the transducer to the bottom. As a result, water
depth readings do not account for the distance from the transducer to the lowest point of
the boat in the water or from the transducer to the water surface.
• To show the depth from the lowest point of the vessel to the bottom, set the offset equal
to the vertical distance between the transducer and the lowest part of the vessel, A
(negative value).
• To show the depth from the water surface to the bottom, set the offset equal to the
vertical distance between the transducer and the water surface, B (positive value)
• For depth below transducer, set the offset to 0.
Use depth and temp data from
Selects from which source the depth and temperature data is shared on the NMEA 2000
network.
Installation
Use this dialog to setup and configure available Echosounder sources.
Source
Select this option to display a list of Echosounder sources available for setup. The settings
you make in the rest of the dialog pertain to the source selected.
Software setup | NSO-evo3 Installation Manual
25
To Next Page
Loading...
