Autopilot
You can activate the autopilot from any panel.
1. Press the Autopilot tile in the Instrument bar or the WheelKey when this is configured
for Autopilot control
2. Select the autopilot mode in the Autopilot pop-up
S Standby
Autopilot is passive. Used when manually steering at the helm
FU Follow-up
Manual steering. The rudder angle is set by the Rotary knob
or by another FU unit
NFU Non-Follow-up
Manual steering. The rudder movement is controlled by
the Port and Starboard buttons in the Pilot pop-up, or by
another NFU unit
A Auto Automatic steering, maintaining the set heading
ND NoDrift
Automatic steering, keeping the vessel on a straight bearing
line by compensating for drift
N Navigation
Automatic steering, navigating the vessel to a specific
waypoint or through a route using GPS data
W Wind * Automatic steering, maintaining the set wind angle
WN
Wind
navigation *
Automatic steering, navigating the vessel to a specific
waypoint or through a route using both wind and GPS data
* Only available if the boat type is set to Sailboat.
¼ Note: You switch the autopilot to Standby mode from any automatic mode by a
short press on the
WheelKey configured for Autopilot control.
Adjust set heading / course / wind angle
Adjust set heading (Auto mode), set wind angle (Wind mode) and
set course (NoDrift mode):
• Tap the
Port or Starboard button in the autopilot pop-up, or
• turn the
Rotary knob.
To Next Page
Loading...
Need help?
General
