10
Simrad RS10 Operation and Installation Manual
Press + or - to step through the available channels one at a time, or hold down
to scroll rapidly through all the available channels. See Appendix C for a listing of
channel charts.
Alphanumeric Entry. This key can also be used for menu selection and for alpha-
numeric entry. Press + or - to scroll the cursor up or down menu options when
navigating menus.
When editing an item containing only numbers, press - to count through the
numbers or hold down to scroll rapidly.
To enter a character, press + to step through the alphabet or hold down to scroll
rapidly.
ENT Enter. Use ENT when navigating menus, to conrm entries and edits.
ESC Escape. Use ESC when navigating menus, to clear incorrect entries, to exit from a
menu without saving changes, and to back up to the previous screen.
CALL/MENU DSC Call Menu. Press to enter the DSC Call Menu and make DSC calls. See Section
5.
Hold down to enter MENU SELECT. Scroll to DSC SETUP to setup your MMSI and
other DSC information. Go to RADIO SETUP to customize your Simrad VHF radio.
See Section 4.
DISTRESS Send DSC Distress Call. RS10U & RS10E only. See Section 6.
PTT Press To Talk. Press PTT to transmit at any time on an allowable channel. This au-
tomatically exits you from menu mode and stops scanning. You must release PTT
to receive a signal.
If PTT sticks, a built-in timer will automatically shut down a transmission after ve
minutes and sound the error beeps.
This time out is required by FCC regulations.
To Next Page
Loading...
Need help?
General
