19
Simrad RS10 Operation and Installation Manual
3-3 RING & BEEP Volume (RING VOL) and (BEEP VOL)
Set the volume level of the incoming signal beeps (RING VOLUME) and/or the error and warning beeps
(BEEP VOLUME) to HIGH (high) or LOW (low) as follows:
1. Select RADIO SETUP, then RING VOLUME or BEEP VOLUME as appropriate.
2. Select a HIGH or LOW volume. (It is possible to turn the beeps o completely by selecting BEEP
VOLUME then OFF.)
3. Press ENT to enable the new volume setting and return to the menu.
3-4 Internal Speaker Connections (INT SPEAKER)
Switch the radio’s internal speaker ON (on) or OFF (o). The external speaker is always ON (on) if a speaker
is plugged into the external speaker jack.
1. Select RADIO SETUP, then INT SPEAKER.
2. Select ON (on) or OFF (o) then press ENT to
enable the setting and return to the menu.
3-5 Set the Priority Channel (WATCH MODE)
If you have a RS10E, watch mode is similar to a dual watch, scanning between the priority channel and
the working channel. CH16 is the priority channel.
However, if you have a RS10U and are operating on USA or Canadian channel banks, you can set the
priority channel to cover both CH16 and CH09 as well as the working channel, as follows:
1. Select RADIO SETUP, then WATCH MODE.
2. Select ONLY 16CH for dual watch mode, or
16CH+9CH for tri watch mode.
RADIO SETUP
> CH NAME
RING VOLUME
BEEP VOLUME
RING VOLUME
> HIGH
LOW
BEEP VOLUME
> HIGH
LOW
OFF
RADIO SETUP
RING VOLUME
BEEP VOLUME
> INT SPEAKER
INT SPEAKER
> ON
OFF
RADIO SETUP
BEEP VOLUME
INT SPEAKER
> WATCH MODE
WATCH MODE
> ONLY 16CH
16CH+9CH
To Next Page
Loading...
Need help?
General
