39
Simrad RS10 Operation and Installation Manual
7-9 Wiring Details
In case a cable is cut accidentally the pinouts are shown here for information only.
Do not cut cables intentionally.
Cable Pinout Color
1 VHF Antenna
2 Power 1. 13.6V DC + Red (thick cable)
2. 13.6V DC - Black (thick cable)
3 External speaker 1. EXTERNAL SPK + White (thin cable)
2. EXTERNAL SPK - Black (thin cable)
4 GPS connector (pins used) 4. NMEA IN + Yellow
5. NMEA IN - Green
2.
Not used
Not used
6. Not used
Not used
Connect the Radio Cables - Rear view of base unit
1. VHF Antenna connection. (Antenna is not supplied.)
2. Combined power and speaker cable. The end of the power cable splits in two:
BLACK. Earth. Connect to the (-) NEGATIVE battery terminal.
RED. Power. Connect to the (+) POSITIVE battery terminal. Check that a 10A fuse is installed on
this power cable, close to the battery.
3. External speaker cable.
4. GPS connector cable.
7-8 Connecting the Radio
There are three sockets at the rear of the radio, as shown. The combined power & speaker socket and
the GPS socket have short connectors already in place but further electrical wiring is required at the
rear of the radio.
To Next Page
Loading...
Need help?
General
