Simrad RS10U User Manual

21
Simrad RS10 Operation and Installation Manual
Section 4 - DSC Setup Menu (DSC SETUP)
4-1 DSC Setup - Menu Options
The following options are available:
Enter your user MMSI. See section 4.2. (If you do not have a user MMSI, see
Appendix D.)
Enter or change the name and/or details of a group.
See section 4.3.
Choose an automatic or manual response to calls (RS10U only). See section
4.4.
Enter or change your ATIS MMSI (RS10E only).
See section 4.5.
Enable/disable the ATIS function (RS10E only).
See section 4.5.
Turn the DSC operation ON/OFF (on/o).
See section 4.6.
Select the type of response to an LL polling request.
See section 4.7.
Sections 1.3 and 1.4 explain how to navigate around the menu and enter, save and change data.
4-2 Enter Your USER MMSI (USER MMSI)
This is a once-only operation. You must enter your user MMSI before you can access the DSC
functions.
You can display and read your user MMSI at any time, but you get only one opportunity to enter your
user MMSI.
1. Select DSC SETUP, then USER MMSID.
2. If this is the rst time that you are entering your user MMSI, a dashed line appears.
Enter your user MMSI along the dashed line. Press ENT to conrm each correct entry and to move
to the next digit.
If you make an error, press - until < appears, then press ENT to backup and correct the entry.
These DSC facilities are available only on the RS10U and RS10E and a valid user MMSI must be
entered to access the DSC functions.
USER MMSID
GROUP SETUP
INDIV REPLY
ATIS MMSID
ATIS FUNC
DSC FUNC
LL REPLY
DSC SETUP
> USER MMSID
GROUP SETUP
INDIV REPLY
INPUT USER
MMSID
–––––––––
USER MMSID
INPUT AGAIN
–––––––––
187654321
MMSID
> STORE
CANCEL
WARNING
A valid USER MMSI must be entered into this radio before these DSC functions can be used. See
below for instruction to Enter Your USER MMSI.

Simrad RS10U Specifications

General

Brand	Simrad
Model	RS10U
Category	Radio
Language	English