What to do if Simrad WR20 RemoteCommander shows communication failure?
If your Simrad Radio displays a communication failure, it could be due to a couple of reasons. First, the handset might be out of range of the base station; try moving the handset closer. Alternatively, the handset might not be paired with the base station. In this case, you should pair the handset to the base station.
Why is data missing from data pages on my Simrad WR20 RemoteCommander Radio?
If data is missing from the data pages on your Simrad Radio, it's likely because only data transmitted on the network will be displayed. Ensure that the necessary data is being sent out on the network.
How to fix a Simrad Radio handset that will not switch on?
If your Simrad Radio handset won't switch on, the most likely cause is a discharged battery. Try re-charging the battery.
What to do if product under control is not responding on Simrad WR20 RemoteCommander?
If the product under control is not responding on your Simrad Radio, a communication conflict may be the cause. Press the product key to refresh the display.
Why is there no backlighting on my Simrad Radio?
If there's no backlighting on your Simrad Radio, the light level might be set to 0. Increase the light level.
Guidance on selecting an optimal mounting location for the Basestation.
Detailed diagram and labels of the WR20 Handset's physical layout.
Using the STBY/AUTO key for Autopilot mode control.
Accessing and navigating the WR20 Setup menus.
Configuring personal preferences like display and sound.
Customizing measurement units for various data.
Options related to product pairing and system setup.
Procedure for pairing the handset with the WB20 Basestation.
Enabling and configuring Bluetooth mobile phone connectivity.
Enabling or disabling control of the connected VHF radio.
How to view and select connected SimNet products.
Engaging the Autopilot and entering active control modes.
Navigating and selecting different autopilot steering modes.
Using the Autopilot in Auto Compass mode for course holding.
Initiating a 'Dodge' maneuver for powerboats.
Performing a 'Tack' maneuver for sailboats.
Engaging Auto NoDrift mode to maintain position against drift.
Using the Autopilot for navigation to waypoints.
Executing a 'Dodge' maneuver within the Auto Nav mode.
Utilizing the Autopilot based on wind direction and strength.
Performing Tack or Gybe maneuvers based on wind conditions.
Understanding and responding to autopilot alerts.
How autopilot alarms are displayed on the WR20.
Warning message for Volvo IPS override events.
Controlling Navstation functions via menus and cursor.
Activating the Man Over Board (MOB) function.
Steps to enable and use mobile phone features.
Detailed guide for pairing the WR20 with a mobile device.
How to initiate and answer calls using the WR20.
Common issues and their solutions for the WR20.
To Next Page
General
