RS81/RS82 VHF
28
E04572
To adjust the dwell time setting, press OK to enter the edit
mode and use the
▲ and ▼ keys to select the desired scan
dwell time. The display will show “XX SECONDS” (with “XX”
denoting the new dwell time) for 2 seconds, then return to
“DWELL” showing the new level (Fig 4.4).
Press O
K to exit the submenus, or the ▲ and ▼ keys to choose a
further option.
4.2 Numbers
The Numbers menu is used to enter ID numbers such as the
MMSI (Maritime Mobile Service Identity) or ATIS numbers (the
latter is applicable only in certain countries), please refer also to
sections 1.3 and 1.5 of the introduction.
Once the Numbers menu option has been selected (see intro-
duction to section 4), use the
▲ and ▼ keys to scroll through the
following menu options:
• Ship’s MMSI (section 4.2.1)
• ATIS number (section 4.2.2)
NOTE The ATIS number option will only be shown if the radio is
ATIS enabled. This feature is only available for sets used in the
Benelux and Rhine/Danube waterways.
To select an option, press O
K. To return to the main menu,
press O
N/C.
4.2.1 Ship’s MMSI
NOTE This option is only available in systems with an AHS82 con-
nected (please refer also to section 1.3).
The Ship’s MMSI function will display the boat’s MMSI num-
ber once it has been entered, or will allow the MMSI number to
be entered when the radio is being used for the first time.
From the Numbers menu (section 4.2) press O
K
to enter the
submenu and select “SHIPS MMSI”. After 2 seconds the num-
ber will be displayed – if it has not been entered yet, the dis-
play will show dashes only (“- - -”), with a flashing dash indi-
cating the cursor position (Fig 4.5, p. 29).
Fig 4.4 - Scan dwell time
DWELL 04
To Next Page
Loading...
Need help?
General
