RS86/RS87 VHF
18
E04819 Issue 1.0
If the radio locks onto a busy channel, pressing OK will manu-
ally continue the scan. All Scan will otherwise automatically
restart when the channel becomes clear.
Note All other stations will also show the All Scan display.
Note While in Scan mode, normal VHF functions are not available.
To exit All Scan, press 16 or O
N/C, or lift the handset from the
cradle.
2.8.1 Dynamic All Scan inhibit
If the radio is constantly locking onto a busy channel during
scanning, this channel can be excluded from the scan by press-
ing SHIFT then 1 while locked on that channel.
The display will show “CHANNEL INHIBITED” and the chan-
nel will no longer be included in the scan cycle.
➞ The channel can be reinstated using the menu option de-
scribed in section 3.1.2.
2.8 All Scan mode
The scan function cycles the RS86/RS87 sequentially through
each enabled channel, pausing when a signal is detected.
Press S
HIFT followed by 1 (SCAN ALL) to enter All Scan mode.
If All Scan is selected while the handset/fistmike is off cradle,
the display will show “PLACE BACK ON CRADLE”. This
function will be canceled, if the handset/fistmike is not returned
to the cradle within 10 seconds.
The display will now show “SCAN ALL”. If the radio detects
a signal, it will lock onto this and the large digits will change
to show the relevant channel number (Fig 2.7).
67
INT
SCAN
ALL
Fig 2.7 - All Scan mode
To Next Page
Loading...
Need help?
General
