Use the VOL ▲ or VOL ▼ key to select another Scanning menu
option, or press O
N/C to return to the main menu.
3.1.3 All Scan show
This function displays all inhibited channels. From the Scan-
ning menu (section 3.1) select “ALL SCAN SHOW” and press
O
K. The display will then change to “SHOWING CHANNELS”
and display all inhibited channels in sequence.
RS86/RS87 VHF
22
E04819 Issue 1.0
From the Scanning menu (section 3.1) select “ALL SCAN IN-
HIBIT” and press O
K. Enter the relevant channel number using
the numeric keypad. The display will show the channel number
and its status – “ALL SCAN” for enabled, or “ALL SCAN IN-
HIBITED” for inhibited channels (Fig 3.1).
Press OK to change the channel’s inhibit status – i.e. if it is en-
abled, pressing O
K will inhibit it, and vice versa. If the channel
is inhibited, it will no longer be included in the All Scan cycle.
Enabling the channel will re-select it.
Additional channels can be inhibited/enabled by entering the
channel number and repeating the above procedure.
To exit, press the V
OL ▲ or VOL ▼ key to select another Scan-
ning menu option, or press O
N/C to return to the main menu.
3.1.2 All Scan reset
This function will reset all inhibited channels. From the Scan-
ning menu (section 3.1) select “ALL SCAN RESET” and press
O
K
– the display will show “CHANNELS RESET” (Fig 3.2).
65
ALL SCANAA
INH IB ITEDB
INT
Fig 3.1 - Selected channel inhibited from scan
CHANNELSSS
RESET
EDBBB
Fig 3.2 - All inhibited channels reset
To Next Page
Loading...
Need help?
General
