Why my Simrad Radio unit will not switch on?
If your Simrad Radio unit won't switch on, there are several potential causes: * A faulty power connection: Check the power connection. * A blown fuse: Replace the fuse and check the power supply current. * Supply voltage above the limit: Ensure the supply voltage is less than 15.6 V.
What to do if Simrad Radio transmissions are weak and the display flashes ANT?
If transmissions are persistently weak and the display flashes 'ANT' on your Simrad Radio, it could be due to: * A damaged antenna: Replace the antenna. * A broken antenna cable: Replace the cable. * Poor contact: Check the antenna sockets and through-deck connector.
Why Simrad Radio will not transmit on 25W but OK on 1W?
If your Simrad Radio will not transmit on 25W but works fine on 1W, the issue might be: * Low voltage when full transmitting current is drawn: Check the power supply. * Some channels are restricted to low power transmission only: Consult your national authority.
What to do if Simrad Radio Scan locks on a channel without a signal?
If the Scan or Memory Scan function on your Simrad Radio is locking onto a channel without a signal, it could be due to: * Noise on the channel holding the scan: Increase the squelch level. * If the cause is not mentioned: Inhibit the channel from the scan.
Why Simrad Radio will not transmit?
If your Simrad Radio will not transmit, it may be because the Scanning or D/W (Dual Watch) function is active. Exit D/W or Scan to enable transmission.
Why Dual Watch is not being entered on Simrad Radio?
If Dual Watch is not being entered on your Simrad Radio, the reason could be: * A priority channel is selected: Select a working channel. * The handset is off the cradle: Replace the handset.
General| Type | VHF Radio |
|---|---|
| Power Output | 25W / 1W |
| DSC | Yes |
| Channels | International and US channels |
| Power Supply | 12V DC |
To Next Page
