The next stage is to specify the coast station the call is to be
routed through. Either manually enter the MMSI number of the
coast station using the numeric keypad, or press the VOL and
VOL keys to scroll through the Coast Station MMSI number
directory (Fig 4.4). Press Ok to confirm the selected entry.
Instruction Manual
33
Part No. E04297
06
COAST 1 AAA
INT
NOTE The MMSI number entered must have two leading zeros
(indicating a coast station), or it will not be accepted.
The display will show “Press Ok To Send” - press Ok to initi-
ate the call, or On/C to abort.
On initiation of the call, the display will show “Attempting To
Connect”. If the call cannot be connected for any reason, the
display will show “Cannot Connect”, then “Pls Wait 15
Minutes” before returning to the default display.
If the call is connected, the display will show “Call In
Progress” (Fig 4.5) - press the PTT key to talk and release to
listen.
Fig 4.4 - Selecting a Coast Station from the coast station directory
NOTE The channel number displayed during the call is determined
by the Coast Station.
Press On/C to end the call, or wait for the other end to replace
the receiver.
07
CALL I N AAA
PROGRESSBB
INT
Fig 4.5 - Call has been connected
To Next Page
Loading...
Need help?
General