5-3
Maintenance
5
1.5 Cleaning the inside of the Nozzle
The leftover in the nozzle interferes with filaments transfer. This interference can cause problems with printing and
filament loading.
The leftover makes the printing filament uneven or clogs the nozzle.
Once melted, the filament can have different properties from the original.
If the leftover in the nozzle is repeatedly heated / cooled, the properties will be changed.
The changed leftover is harder to pull out, and easily stacked in the nozzle.
Therefore, it is recommended to clean the nozzle regularly if you want to use nozzle for a long time.
Nozzle cleaning is recommended when replacing it to another material of filament. This is because each material has
different properties.
Especially, be sure to clean the nozzle before and after using PVA(PVA+) or FLEXIBLE.
Please follow the instructions below when cleaning.
1 Pull the lever on the right side of the nozzle and then the top lever to the direction of the arrow to lock the lever.
1
2 Remove the snap ring from the nozzle.
SNAP-RING
To Next Page
Loading...
