1.4 Print Job Management -------------------------------------------------------------------------------------------------3-13
1.5 Printing with Two Types of Filamentst ------------------------------------------------------------------------------3-14
1.6 Changing Filaments ----------------------------------------------------------------------------------------------------3-14
Chapter 4 Printed Output Check
1. Printed Output Check --------------------------------------------------------------------------------------------------- 4-2
1.1 Detaching Printed Output ----------------------------------------------------------------------------------------------- 4-2
1.2 PVA(PVA+) Filament Removal Guide ------------------------------------------------------------------------------- 4-4
1.3 Improving Printing Quality ---------------------------------------------------------------------------------------------- 4-4
2. If problems persist ------------------------------------------------------------------------------------------------------ 4-5
Chapter 5 Maintenance
1. Machine Cleaning ------------------------------------------------------------------------------------------------------- 5-2
1.1 Cleaning Case Maintenance ------------------------------------------------------------------------------------------- 5-2
1.2 Printer Interior Cleaning ------------------------------------------------------------------------------------------------- 5-2
1.3 Periodical Inspection ----------------------------------------------------------------------------------------------------- 5-2
Oil/Grease Inspection ----------------------------------------------------------------------------------------------------- 5-2
1.4 Flexible bed and Nozzle Cleaning ------------------------------------------------------------------------------------ 5-2
1.5 Cleaning the inside of the Nozzle -------------------------------------------------------------------------------------- 5-3
1.6 Nozzle Tip Cleaning ------------------------------------------------------------------------------------------------------5-10
2. Error Message and Solutions --------------------------------------------------------------------------------------5-13
3. Problems and Solutions ---------------------------------------------------------------------------------------------5-15
3.1 In Cases where Filament is Cut Between the Extruder and Nozzle -----------------------------------------5-15
3.2 When Filament End is Visible Outside the Cartridge After Unloading --------------------------------------5-15
3.3 Solution for Notification 401, 601 ------------------------------------------------------------------------------------- 5-16
4. Replenishing Consumables ----------------------------------------------------------------------------------------5-19
4.1 Bed Replacement --------------------------------------------------------------------------------------------------------5-19
Removing Flexible Bed -------------------------------------------------------------------------------------------------5-19
Installing Flexible Bed ---------------------------------------------------------------------------------------------------5-19
4.2 Filter Replacement -------------------------------------------------------------------------------------------------------5-19
4.3 Cartridge Replacement -------------------------------------------------------------------------------------------------5-21
4.4 Nozzle Replacement ----------------------------------------------------------------------------------------------------5-21
Chapter 6 Appendix
1. Type of Filaments (Material, Color) ------------------------------------------------------------------------------- 6-2
2. Using an open material ----------------------------------------------------------------------------------------------- 6-3
2.1 Installing from the front -------------------------------------------------------------------------------------------------- 6-3
2.2 Installing from the top ---------------------------------------------------------------------------------------------------- 6-6
To Next Page
Loading...
