Sindoh M611 - Page 185

179
Printer Service
Printer service
 Margin Adjustment
To adjust margin,
M611/M616
M612/M617
1. Select Printer service in the diagnostic
mode.
2. Select PRT Registerration
3. Select Margin adjust
4. Select any one of Left margin,
Top margin, Back-left margin, Back-top
margin to change the value..
5. Set the wanted value by using the arrow
direction keys and press OK.
6. Press [Back] to exit.
1. Select Printer service in the diagnostic
mode.
2. Change values of Left margin, Top
margin, Back-left margin, Back-top
margin of PRT Registerration-Margin.
3.When entering negative values, type in
the numbers first and press # key.
4. Press SAVE to exit if all the values are
set .
5. Press EXIT to exit.
The print margin ranges are as the following and it can be changed by 1
unit(=0.2mm).
Class.
Value
Top Margin
-25 ~ +25
Left Margin
-25 ~ +25
Adjusting Top Margin +5 makes the image to move
down 1mm.
Adjusting Top Margin -5 makes the image to move
up 1mm.
Adjusting Left Margin +5 makes the image to move
to the right by 1mm.
Adjusting Left Margin -5 makes the image to move to
the left by 1mm.