39
Turning Square Corners
• Cut out approximately 2 cm (51/64 inch) from the
corner, in line with the overedge seam edge.
• Sew one stitch beyond point (A) and stop.
• Raise needle and presser foot.
• Pull the fabric to the rear of the machine just
enough to release the thread caught on the finger
of the throat plate.
Note: Presser foot has been removed to show
detail.
• Turn the fabric and lower the presser foot so that
the knife is positioned in line with the cut edge.
• Pull slack threads up, then start to sew.
• Fold the fabric with the wrong sides together and
sew.
• Press the pin tucks in the same direction.
(1) Outside Corner
• Cut fabric at seam edge.
(2) Inside Corner
2 cm
2 cm
Cutting
line
Cut Slit
Cutting line
A
To Next Page
Loading...
