Singer 6160 - Straight Stitching; Menjahit Lurus

36
STRAIGHT STITCHING
直线线迹
MENJAHIT LURUS
Straight stitch is most frequently used for all types of sewing. Let’s begin by following the
steps below.
NOTE:Basedupontheweightofthefabric,slight“netuning”ofthetension
may be desired.
A.Thread tension control
B. Reverse stitch button
C. Presser foot lifter
1.SETTINGS
Presser foot - General Purpose Foot
Thread tension control - 5
6. First turn the handwheel toward you (counter-clockwise) until the needle is at its highest
position. Raise the presser foot, draw materials to the rear and cut off excess thread
with the thread cutter located on the bottom of face cover as shown.
2. Pull both threads under the presser foot toward the back of the machine, leaving about 6”
(15cm) clear.
3. Place the fabric under the presser foot and lower the presser foot lifter.
4. Turn the hand wheel toward you (counter-clockwise) until the needle enters the fabric.
5. Start the machine. Guide the fabric gently with your hands. When reaching the edge of
the material, stop the sewing machine.
NOTE: To secure the stitching and avoid raveling, press the reverse stitch switch
and sew a few stitches at the start and end of the seam.
NOTE: The Needle Plate has both Metric and Inch Markings as an aid for guiding
your fabric when sewing a seam.
1. 配置设定 ：
安装压脚 - 万能压脚
上线张力 -5
直线线迹是最常用的一种线迹。请按照以下步骤学习如何进行直缝。
提示 ：根据不同织物，适当调节上线张力。
A. 上线张力调节器
B. 倒针按钮
C. 压脚提升杆
6. 逆时针转动手轮，将机针停在最高位。提升压脚，将织物向后左方移出，并用面板上的割线器
切断缝线。
提示 ：针板上刻有以毫米和英寸为单位的度量线，以帮助缝纫时正确送料。
2. 将压脚下的线头拉向机器后方约 15 厘米长。
3. 把布料放在压脚下，放下压脚。
4. 逆时针转动手轮，直到针刺入布料。
5. 启动机器，用手轻轻地配合送料。当缝纫到布料边缘时停车。
提示 ：在缝纫开始和结束时，使用倒缝按钮，可以防止缝线脱落。
100 stitch model :
80 stitch model :
60 stitch model :
00
00
00