9
DIGITIZING
Digitizing is the process of applying stitch data to artwork. The digitizing methods
in the PSW 2.00a are quick, easy and efficient.
The Left and Right mouse have different functions in the digitizing process. The
Left mouse is mainly used for inputting reference points, direction lines, and first
& last points. The Right mouse introduces pop-up menus that offer further
choices for design adaptations.
CREATION METHODS
Creation methods are used to generate various stitch effects to artwork. There
are 4 Basic Categories:
Branches (Reference Line Fill)
This method defines the length and inclination of stitches by
drawing the reference lines at various lengths and inclinations.
Outline Fill
This method allows drawing around an area, for filling with stitches
at varying angles of inclination.
Complex Fill
This method allows drawing around an area, for filling with stitches
of varying pattern types or textures. It has the ability to create
blocks with holes inside.
Running Stitches
This method allows inputting a sequence of points representing a
line of stitches.
• Running stitches
• Column stitches
• Cross stitches
CREATING STITCHES – The Digitizing Process
Digitizing can be done using an Autotracing method (referred to as Magic
Wand), or by inputting points Manually. To practice these 2 methods, a Teddy
Bear design will be digitized. In this design, the fill-stitch areas will be digitized
automatically with Autotracing
, and then the design outline will be digitized
manually
.
To Next Page
Loading...