18
• From Main Menu, click on Edit: Edit Outline.
• Click on the Dolphin nose.
• Click the right mouse to access pop-up menu; click on Properties.
• Click on Pull Compensation.
• Change Outline Shift to 6; click OK and the block is compensated.
• Click on Dolphin belly.
• Click the right mouse to access pop-up menu; click on Properties.
• Click on Pull Compensation.
• Change Outline Shift to 6; click OK and the block is compensated.
• Click on Cancel (the red ‘X’) to exit the edit function.
12. From the Main Menu, Click on Utilities: Undo Color Reduction, and the
“reduced” color (black) from the Dolphin image file resurface.
13. From the Vertical tool bar, click on Manual Input icon.
14. Digitize the eye of the Dolphin as follows:
• Using the left mouse, click reference points around the eye area.
• When finished inputting points, click right to access pop-up menu.
• Click left mouse on Finish Outline.
• Prompt-line reads “Input direction”; click left mouse anywhere on
screen, to anchor a point. As mouse pointer is moved, an elastic line
is pulled from the anchor point. This is the angle of inclination.
Choose an angle, then click left to secure the angle line in place.
• Prompt-line reads “Input the entry point”; click the left mouse where
stitching is to begin for this block of stitches.
• Prompt-line reads “Input the exit point”; click the left mouse where
stitching is to finish for this block of stitches.
• Stitches for the eye area of the dolphin are complete.
To Next Page
Loading...