KNOWING YOUR SEWING MACHINE
3
ACCESSORIES
1. Needles
2. Twin needle
3. Seam ripper/ lint brush
4. Small screwdriver
5. Screwdriver for needle plate
6. Auxiliary spool pin
7. Bobbins (4 total - 1 in machine) *
8. Spool pin cap
9. Zipper foot
10. Satin stitch foot (Z)
11. Button sewing foot (O)
12. Blind hem foot (H)
13. Buttonhole foot (B)
The foot that comes on your Sewing machine is called the All Purpose foot (J) and will be used for the majority of your
sewing. The Satin Foot (Z) is another very useful foot and should be used for most decorative sewing.
* Important! Your machine uses SINGER® Class 15J bobbins. Use only this style of bobbin in your machine.
SETTING UP YOUR MACHINE
Be sure to wipe off any surplus oil from needle plate area
before using your machine the first time.
POWER LINE CORD, FOOT CONTROL
Make sure that the sewing machine is turned off (the power
switch is set to ”O”), then connect the plug of the power line
cord into the cord socket (1) and wall outlet (2) as illustrated.
Connect the foot control plug (3) into the machine socket.
This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Always disconnect the machine from power supply by removing the plug from the wall-outlet.
POWER / LIGHT SWITCH
Your machine will not operate until the power / light
switch is turned on. The same switch controls both the
power and the light.
When servicing the machine, or changing needles, etc.,
machine must be disconnected from the power supply.
Set power/light switch at “OFF”
Power / light switch
“OFF”
Power / light switch
“ON”
To Next Page
Loading...
