KNOWING YOUR SEWING MACHINE
7
THREADING THE TOP THREAD
A. Raise the presser foot lifter. Always be sure to raise the presser foot
lifter before threading the top thread. (If the presser foot lifter is not
raised, correct thread tension cannot be obtained.)
B. Turn the hand wheel toward you until the needle is in its highest
position and the thread take-up is visible.
C. Thread the machine with your left hand while firmly gripping the
thread with your right hand in the following order as illustrated.
* Guide the thread through thread guide (1).
* Pull the thread into the tension discs (2) (which are located inside the machine). Then guide the thread to the bottom
of the groove.
* Do a U-turn around the inside of the tab (3).
* Pass the thread through the thread take-up (4) from right to left.
* Pull the thread into the inside of the take-up lever until it reaches the eye of the lever.
* Guide the thread into the thread guide (5).
* Pass the thread through the eye of the needle (6) from front to back. (See following page for instructions on
operation of the Automatic Needle Threader.)
IMPORTANT:
To verify that the machine is threaded properly in the tension discs, do this simple check:
1.) With the presser foot raised, pull the thread towards the back of the machine. You should detect only a slight
resistance and little or no deflection of the needle.
2.) Now lower the presser foot and again pull the thread towards the back of the machine. This time you
should detect a considerable amount of resistance and much more deflection of the needle. If you do not
detect the resistance you have miss-threaded the machine and need to re-thread it.
To Next Page
Loading...
