KNOWING YOUR SEWING MACHINE
4
SPOOL PINS
HORIZONTAL SPOOL PIN for normal
thread spool
Place thread spool on the pin and secure with a spool
cap to ensure smooth flow of thread. If the thread
spool has a thread retaining slit, it should be placed to
the right.
AUXILIARY SPOOL PIN for large
thread spool
Attach the auxiliary spool pin. Place a spool of thread
on the spool pin. The spool pin cap is not used with
the auxiliary spool pin.
PRESSER FOOT LIFTER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or
remove fabric.
3. Lift it to its highest position to change the presser foot
to insert or remove thicker fabric.
FEED TEETH CONTROL
The feed teeth control the movement of the fabric
that is being sewn. Feed teeth should be raised for
all general sewing purposes and lowered for
darning, freehand embroidery and monogramming
so that you, not the feed teeth, are guiding the
fabric.
Note: To re-engage the feed teeth, move the lever
to its raised position, then turn the handwheel one
full revolution.
To Next Page
Loading...
