Sinocare Safe-Accu User Manual (English)

Questions and Answers:

J
Julia JohnsonAug 14, 2025
What to do if Sinocare Safe-Accu doesn’t begin test after applying a blood sample?
- W
  wagnermichaelAug 14, 2025
  If the meter doesn’t start after applying blood, consider these possibilities: * There might not be enough blood sample. In this case, repeat the test using a new test strip and ensure you provide an adequate sample. * The blood sample may have been applied to the wrong area of the test strip. Repeat the test with a new strip, making sure the blood is drawn into the correct area. * The test strip may be used. Repeat the test with a new test strip. * The test strip was exposed to air too long after opening. Finish the test immediately after taking a test strip from a vial or package.
E
Edward HarrisAug 17, 2025
What to do if Sinocare Blood Glucose Meter shows result above measurement limit?
- S
  Steven HuangAug 17, 2025
  If your Sinocare Blood Glucose Meter displays a result above the measurement limit, which is higher than 600 mg/dL or higher than 33.3 mmol/L, use a new test strip and test again. If the meter continues to display “HI”, it is important to immediately contact a healthcare professional for assistance.
C
Christopher BrownAug 21, 2025
What to do if Sinocare Safe-Accu Blood Glucose Meter shows result below measurement limit?
- C
  Catherine HunterAug 21, 2025
  If your Sinocare Blood Glucose Meter shows a result below the measurement limit (less than 20 mg/dL or less than 1.1 mmol/L), use a new test strip to test again. If the meter still displays “LO”, call your healthcare professional immediately.

Sinocare Safe-Accu Specifications

General

Measurement Range	20-600 mg/dL
Sample Type	Capillary whole blood
Test Time	10 seconds
Power Source	2 x AAA batteries
Memory Capacity	200 test results
Operating Conditions	10-40°C, 10-90% RH
Sample Volume	0.6 μL
Automatic Shutoff	Yes, after 3 minutes
Weight	50 g (without batteries)