SINTERIT Lisa Pro - Page 42

Sinterit LISA PRO User Manual | 42
10. Transfer the powder from the Print Bed to Overow Bin
(through the Overow Bin gap).
11. Also, put the remaining powder around the Beds to Overow
Bin, then press the DONE button.
• Use the Spatulas and the Brush to thoroughly clean the
space, especially under the Recoater guide bar.
DONE
CLEANING STEP 7/8
Cleaning the Print Bed
Clean area around the Print Bed
Put the temaining powder into
Overow Bin
The screen of the cleaning Print Bed.
12. Unlock and clean the Overow Bin. The magnetic blockade
deactivates for 10 seconds. After 10 seconds, it will re-
activate.
13. When the cleaning is nished and the DONE button is
pressed, a screen will appear with a message about the
amount of powder that needs to be added to refresh
the powder taken out of the printer. This is a necessary
process, especially for polyamides, to print correctly in the
next printing cycle
14. After adding Fresh Powder as shown on the screen and
pressing the DONE button, the cleaning process will be
completed. The printer will return to the MAIN MENU
screen.
BACK DONE
UNLOCK OVERFLOW BIN
CLEANING STEP 8/8
Cleaning the printer
Empty the Overow Bin
Overow Bin unlock screen.
BACK DONE
CLEANING STEP 9/9
Cleaning the printer
Add 0.2 litres of Fresh Powder
to the powder removed from the printer
The printer will show you how much to add Fresh
Powder to refresh the powder from the printer.