This product requires assembly.
1. Remove the packing materials from around your tool. Do not discard the
packing material until you have carefully inspected and satisfactorily oper-
2. Separate and remove all loose parts from the shipping container(s). Check
parts against the list of loose parts.
3. Carefully lift the tool from the carton by using the carrying handle and place it
on a firm, level work surface.
4. Remove the protective oil that is applied to all unpainted metal surfaces. This
coating may be removed with a soft cloth moistened with kerosene or WD-
(do not use acetone, gasoline or lacquer thinner for this purpose).
5. After cleaning, cover the unpainted surfaces with a good quality household
6. Inspect the tool carefully to make sure no breakage or damage occurred
7. The saw is factory set for accurate cutting. After assembling it, check for
accuracy. If shipping has influenced the settings, refer to specific procedures
explained in this manual.
8. When boxed or during storage and transportation the saw head is locked
in the down position. To release the head apply downward pressure to the
handle and pull out the lock pin and allow the head to rise gently to its upper
Never carry the tool by the slide rails, this may cause blade damage.
Never carry the tool by the cord or head assembly power switch handle. Dam-
age to insulation could cause an electric shock. Damage to wire connections
If any parts are missing do not operate this tool until the missing
parts are replaced. Failure to do so could result in serious personal injury.
Do not connect to power supply until assembly is complete. Fail-
ure to comply could result in accidental starting and serious personal injury.
Before moving the saw: Lock the mitre lock knob in 45° position.
Lock bevel lock lever. Pull the head assembly completely toward you and
tighten the slide rail lock knob. Lock head assembly in the down position.
To Next Page
Loading...
