9
POWER SUPPLY
This SIP mitre saw is fitted with a standard 230v ~ 13 amp plug. Before using
the saw, inspect the mains lead and plug to ensure that neither are damaged.
If any damage is visible have the saw inspected / repaired by a suitably qualified
per-son. If it is necessary to replace the plug a heavy duty impact resistant plug
would be preferable.
The wires for the plug are coloured in the following way:
Yellow / green Earth
Blue Neutral
Brown Live
As the colours of the wires may not correspond with the markings in your plug,
proceed as follows: The wire which is col-oured blue, must be connected to the
terminal marked with N or coloured black. The wire which is coloured brown,
must be connected to the terminal, which is marked L or coloured red. The wire
which is coloured yellow / green should be con-nected to the terminal which is
coloured the same or marked
Always secure the wires in the plug terminal carefully and tightly. Secure the
cable in the cord grip carefully.
To Next Page
Loading...
