1.0 Introduction----------------------------------------------- 1
1.1 Safety guidelines---------------------------------------- 1
1.2 Safety notices-------------------------------------------- 1
1.3 Limited One Year Product Warranty----------------2
Chapter 2 Installation and Set Up
2.0 Position the grinder------------------------------------- 3
2.1 Unpacking the grinder----------------------------------3
2.2 Leveling the Base--------------------------------------- 4
2.3 Reel drive motor----------------------------------------- 5
2.4 Connecting the service---------------------------------6
Chapter 3 Preparing to Grind
3.0 Prepare the cutting unit for grinding---------------- 8
3.1 Mounting the cutting unit-----------------------------10
3.2 Reel Diameter Tape™--------------------------------13
3.3 Measuring the reel-------------------------------------15
3.4 Adjusting the cutting unit-----------------------------16
3.5 Clamping the reel--------------------------------------- 24
4.0 Setting the carriage stops for spin-----------------25
4.1 Engaging the spin motor to the reel---------------27
4.2 Spin grinding-------------------------------------------- 30
Chapter 5 Relief Grinding
5.0 Indexer adjustments---------------------------------- 36
5.1 Remove the spin grinding stone------------------- 38
5.2 Mounting the indexer and relief stone------------ 40
5.3 Setting the relief angle--------------------------------41
5.4 Engaging the indexer--------------------------------- 42
5.5 Aligning the indexer----------------------------------- 43
5.6 Setting travel stops------------------------------------ 46
5.7 Checking the indexer--------------------------------- 47
5.8 Adjusting for variations in the amount of relief- 50
5.9 Relief grinding------------------------------------------ 52
6.0 General maintenance---------------------------------57
6.1 Aligning the head vertically--------------------------58
6.2 Aligning the head horizontally---------------------- 60
6.3 Dressing the grinding stone------------------------- 61
6.4 Adjusting the grinding head bearings-------------62
6.5 Mounting the grinding stone------------------------ 64
6.6 Aligning the fence--------------------------------------66
6.7 Adjusting the spin motor belt------------------------69
6.8 Adjusting the grinding motor belt------------------ 71
To Next Page
Loading...