Pocket Printer A6 User’s Guide
SiPix Technical Support http://www.sipixdigital.com/support/
18
Further, you can prevent the HotSync Manager software from automatically starting
when you boot your computer. Typically, you would simply start the software when it
was needed. Please contact the vendor of the PDA for additional information on this
matter.
Infrared Port Communications: troubleshooting
Please note: There are a number of factors that affect IR communication; we've
listed them below. But it's important to remember that not all computers are
identical when it comes to the configuration and setup, especially where the BIOS
is concerned. For that reason, we encourage you to contact the manufacturer with
questions specific to the system you are using. Bottom line: make sure that you
are using updated, accurate information relative to your hardware /software
configuration.
System BIOS/IR Port is not enabled: Refer to the documentation that was
provided with your system to access the system BIOS. Find the Infrared Data Port,
and ensure that this port is not disabled. If you are given a choice for the COM
port, you should select COM 4; if you are given a choice for Infrared Mode, you
should select FAST IR. Save any changes that you have made, and restart your
system.
Infrared communication function is not enabled: Your computer's IR port may
not be enabled. Ensure that the Infrared communication function is enabled. The
Control Panel should have an Icon for Infrared; double click the Icon. Looking
under the OPTIONS tab, ensure that the Enable Infrared Communications option is
checked. Select the APPLY button, if you've made any changes.
Infrared Port is not visible in the Device Manager: Check to ensure that the
Infrared Port is visible in the Device Manager, and that there are no exclamation
points (!) or Xs (x) next to the name. To access the Device Manager, right-click on
MY COMPUTER, select PROPERTIES, and select the Device Manager Tab.
To Next Page
Loading...