Siruba F007D - How to Change Oil; How to Replace the Oil Filter; Lubricate the Needles and Threads; How to Replace the Needles

1.31. M < 1 )Jill ,~ ~ M 2. ti :ffi ~ j~
ltillliJitll .(llf5)
2 .a g-ut* a • a ilt ,ftl ~ Bn ~ ~ m w
II M ti J! • li tdl I Jll It &'3 • (lg ill _ij J!
--~.
D
HOW 1U CHANGE OIL
!.Loosen screw (1), drain all the
oil from the tank, then fasten
the screw. (Fig 5)
2.For extending the
the machine, change
the initial 4 weeks
after that, change
four months.
life of
oil after
operation.
oil every
HOW TO REPLACE TilE 0 IL FILTER
This machine is equipped with an
oil filter, and the filter must
be cleaned every month. Replace
the filter if necessary.(Fig 6)
LUBRICATE 'mE NEEDL~ AND 111READS
Fill reservoir (1) and <2> with
silicone oil to prevent the thread
from breaking.(Fig 7)
Fig 7
HOW 1U REPLACE niE NEEDLES
!.See Table 2 for the sizes and
the specifications of the
needles.
2.Loosen screw (1), then pull out
the used needles. Inesrt the new
needles into the holder holes
as far as they can go, and let
the long groove of the needle
face you. (Fig 8)
3.Fasten screw <1>.
- 3 -
From the library of: Superior Sewing Machine & Supply LLC