2.2 Procedure for Hardware Installation
2.2.1 Hardware Requirements
• ADSL/ADSL2/ADSL2+ Internet subscription
• 9V AC power adapter
• RJ-45 Ethernet cable
• RJ-11 ADSL line
2.2.2 Decide where to place your ADSL2+ Modem
You can place your ADSL2+ Modem on a desk or other flat surface, or you can mount it
on a wall. This location must be close to a power connection and your ADSL/Telephone
connection.
2.2.3 Setup LAN connection
Connect an Ethernet cable to one of your computers.
2.2.4 Hardware Setup Procedures
1. Connect the RJ-11 cable from the DC-227 to your ADSL line.
2. Connect the RJ-45 line from your PC to an Ethernet port on the DC-227.
3. Plug the power supply into a wall outlet.
2.2.5 Power on
Connect the power-adapter to the power inlet port and connect it to a wall outlet, this
product will automatically enter the self-test phase. When it is in the self-test phase, the
Power LED will not be lighted for about 15 seconds, and then Power will flash 9 times to
indicate that the self-test operation has finished. Finally, power will be lit continuously to
indicate that this product is in normal operation.
To Next Page
Loading...