HM30 User Manual v1.3
75
2024 SIYI Technology Copyright
Mark
If it is your first time to add a new connection in QGC, please do not check the option
“Automatically Connect on Start”. It can be checked later when you confirm that the
datalink is established successfully.
4.4.2 Mission Planner
1. On HM30 ground unit, go to “Settings” and set “Type-C” for “Datalink Mode”, and
configure the correct baud rate.
2. Make the Type-C connection between HM30 ground unit and the Windows
device. HM30 ground unit will be recognized as a COM device in Windows
system.
3. Run Mission Planner, select the relevant port and match the baud rate.
To Next Page
Loading...
