QuickCollect 1 - 1
User Manual
1
Introduction
Safety Messages
WARNING! Your safety is extremely important. Read and follow all warnings
in this document before handling and operating the equipment. Failure to
observe the safety warnings may result in personal injury and/or damage to
the equipment and data.
WARNING! - Warning messages are used to alert you to an operating procedure,
practice, condition or statement that must be strictly observed to prevent equipment
damage or destruction, or corruption to or loss of data.
IMPORTANT: Important messages means that there is a risk of product or property
damage if the instruction is not heeded.
Personnel Safety
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from moving parts.
Do not overreach. Maintain proper footing and balance at all times to enable better
control of the device during unexpected situations.
Use safety equipment. Always wear eye protection. Non-skid safety shoes, hard hat or
hearing protection must be used in the appropriate settings.
Do not repair or adjust energised equipment alone, under any circumstances. Someone
capable of providing first aid must always be present for your safety.
To work on or near high-voltage equipment, you should be familiar with approved
industrial first-aid methods.
Always obtain first aid or medical attention immediately after sustaining an injury.
Never neglect an injury, no matter how superficial it seems.
Device Safety
Devices must only be serviced by qualified SKF repair personnel.
Use only accessories recommended or provided by SKF or the manufacturer.
Energised equipment
Never work on energised equipment unless authorised by a responsible authority.
Energised electrical equipment is dangerous. Electric shocks from energised equipment
can be fatal. If you must perform authorised emergency work on energised equipment,
be sure that you comply entirely with approved safety regulations.
To Next Page
Loading...
Need help?
General
